industrial repair agent > wear abrasion resistant epoxy ceramic coating repair agent

wear abrasion resistant epoxy ceramic coating repair agent

BD216 anti wear abrasion resistant epoxy ceramic coating repairing agent

Product description of our BD216 anti abrasion wear resistant repair agent ceramic epoxy coatings:
BD216 wear abrasion epoxy ceramic coating resistant repairing agent is the high performance wear&corrosion resistant polymerization ceramic material compounded
by high performance wear&corrosion resistant material(such as: ceramics, silicon carbide, silicon carbide, titanium alloy)
and modified toughening heat resistant resin.It’s used in repairing and pre-protecting of general duty fine particles erosive wear of the pump body, impeller, fan shell,the pipe screw conveyor and so on.

Performance index:

product name	physical state	standard packaging	volume (cm3)	operational time limit (25℃)	time can be put into use (25℃)
BD216 abrasion wear resistant epoxy coating repair agent	paste	500g/set Two- component	240	45min	24h

color	density (g/cm3)	compressive strength) (Mpa) GB1041-2008	tensile strength (Mpa) GB6329-2008	shear strength (Mpa) GB7124-2008	bending strength (Mpa) GB1042-1999	hardness （Shore D） ASTM-D-2556	working temperature （℃）
gray	2.43	103	39	23	54	89	-60～160

How to use:
1.Surface treatment: Do coarsening treatment on the pending-repair area, grinding with angle grinder or sand blasting and so on, the surface after coarsening treatment should be cleaned,
the surface after this treatment should be the one coarsening,dry and fresh substrates,should be no greasy dirt and dust.

2.Preparation:According to weight ratio 8:1 or volume ratio 4:1, make A and B two components mix uniformly,
and use it up within 30 min. According to the actual temperature,configuration can be appropriately a little more in winter,
proper less in summer.If the temperature is too low,you can properly heat up the A component to reduce viscosity for
easy to configure.

3.Coating: The suitable coating thickness of BD216 is 2～8mm.Make mixed-up material spread coating on the pending-repair area layer by layer, the first layer should be compacted,make it infiltrate fully with the substrates.
Repair the surface to be smooth after the coating spreading in the suitable size or use BD406 corrosion resistant repairing agent
to coat on the surface of the coating,this material can’t do machining,so you should pay attention to controlling the coating
thickness to avoid appearing interference phenomenon in the assembly.

4.Curing: Cure for 24 hours at the temperature of 25℃ before using.If the temperature is low,
should heat it up or prolong curing time to promote the curing.General construction in winter,
you can use iodine tungsten lamp do irradiation heating with 40cm distance from the coating.

Packaging specification:
Two-component,500g/set,packed in a common plastic drum,8 sets/carton or 16 sets/carton.

Transportation and storage:
Sealed storage in the cool and dry place.The warranty period is 24 months.Avoid placing it upside down,
knocking against and transporting it as a non-dangerous product during transportation.

Product packaging photo of BD216 wear abrasion resistant repair agent putty two parts paste epoxy compound:

------分隔线----------------------------